Q3-innovations AlcoHAWK CA2010 Manual do Utilizador descarregar pdf (Página 11)

Step 2) WAIT until the unit displays “READY CAL” and you hear a

SINGLE BEEP.

Step 3) Take a DEEP BREATH AND BLOW STEADILY (for at least 5

seconds) until a DOUBLE BEEP sounds to signal completion

of the testing. Do not cover the BREATH OUT hole.

Step 4) WAIT approximately 5 seconds until the unit displays

“RESULT” and your pollution check result will be displayed

using one of the responses below:

PAS - No pollutants were detected in your device.

CAL - Pollutants were detected. Please contact the Q3 Service

Center for instruction. (backlight will turn red)

ACCESSORIES

Visit our online store at www.q3ats.com to purchase the following

accessories.

• Mouthpieces

• 12 Volt DC Adapter

• Wall Adapter

• Soft Carry Pouch

• Hard Case

VERIFICATION AND CALIBRATION

Calibration of the CA2010 occurs during manufacturing using advanced

alcohol simulation equipment. The manufacturer passes known

alcohol concentrations through the sensor to set baseline values for

testing. During testing, the unit compares users’ breath samples to

these baseline values. If the verication determines that the BAC is not

consistent with actual BAC levels, a technician calibrates the unit. The

accuracy of breath alcohol testers can uctuate over time, depending on

frequency of use and operating conditions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Q3-innovations AlcoHAWK CA2010 Manual do Utilizador Página 11